- Large box or Foam Display board (foldable)
- Wood dowel or old broom handle (32" long)
- X-acto knife (only to be used by Adult)
- Pencil and Ruler
- Craft Foam
- 2 pillowcase for curtains (optional - use only one)
- Craft glue (tacky white)
- We used a foam display board, available at office supply stores for about $10-$12 It measured 36" tall and 24" wide in the front (sides are 12" wide). You may also cut apart a large box that is roughly this same size, so that you will have a front and two sides that will fold.
- Draw an opening that is (23 inches from the bottom) 9 inches high and 18 inches wide. This opening can either be squared off at the top or arched like ours. With a piece of board underneath the area to be cut out, carefully cut the opening with an X-acto knife. Children should be a distance away while this is being done.
- You will also have to cut a small hole (about the size of a cork) on each side piece, about an inch from the top. This is to slide the dowel through to hold the curtain. The hole should be about 5 inches back from the front edge.
- Using the craft foam, cut out pieces to decorate the theatre and attach with glue.
- For curtains, cut a two inch, skinny slit (at the closed end) on each side of the pillowcases. This will allow you to slide the pillowcases onto the dowel and then position the dowel into the side openings. If you prefer to only use one pillow case, you can cut the side and top of the case and then fold fabric out flat to make a larger piece of fabric. About an inch from the top, and about 4-5 inches apart, make holes just big enough so that the dowel will slide through. Cut a few slits to accomodate arms of puppeteer.