Back HOME Printer

Instructions

  1. Using foam hearts that are approximately 2 inches in diameter,  cut two small slits (about 3/4 in apart) into the center of each heart.
  2. Cut a 7-8" piece of ribbon for each napkin ring and then thread through pre-cut slits in heart.  We rolled up a cloth napkin to tie our napkin rings around, so that the diameter would be just right.  In lieu of a napkin, you can tie around a paper tube, such as from a paper towel or t paper tube for the correct diameter.  Be sure it isn't so tight that you can't slide it off however.
  3. After tying ends, cut leaving about a half inch tail on each side.

Need:

  • Foam Hearts  - approx 2 inches wide (or cut from Craft Foam)
  • 1/4 inch Red ribbon
  • Scissors with pointy end